This week I worked on creating new paper roller mechanism that will roll out paper after print rather then rolling it in. With help of...

This week I help Roman with golf cart. With help of lot of people, we took the motor controller out from another golf cart. Also work on...

This week I was test printing the pen plotter to see the accuracy as well as test paper roller and sensor. Everything came out to be...

This week I worked on testing each of penplotter. One of the main things I worked on was centering the sketch file onto the pen plotter....

This week I working on testing pen plotter accuracy and speed. Also Worked on centering the image for printing. The image on the left is...

This week Me and Roman worked on creating a new UI for pen plotter. For this UI we are using "Svelte" framework for Frontend and most...

This week I worked on getting single font writing to work. This picture above first read the .txt file and changes "tabs" into 4 spaces...

This week I worked on creating a new slider for Pen holder. Main point of this update part is to reduce the shakiness when plotting. I...

This week I work on creating a processing server which will take User image from Raspberry PI, converted into g code and send it back to...

This week I worked on assembling other side of Rod holder to the base. With help of Joao we manage to mount the other side of rod holder...

This is the photo of me Laser Cutting some rod holder for base pieces. For this pieces, I'm using 1/4 acrylic and going to be using L...

This week I worked on other side of rod holder. The center part will have a timing pulley where the belt will connect with stepper motor...

This week I worked on improving the Rod holder to make it more efficient and easier to manufacture. Some of the stuff I implanted on my...

This week I was mostly working on finding perfect size for linear bearing and rod to fit perfectly. After couple of 3d printing I found...

Start of the Week I worked on designing new Pen Holder for the new Pen Plotter Design. I will be adding new set of rod on the opposite of...

This week I worked on testing PCB with Raspberry pi. Everything was working good until I connected with raspberry pi. The raspberry pi...

This week I was mostly worked on Docker. I was having some trouble getting docker to work at first, but with help of Roman, we got it to...

This week I was troubleshooting trying to run Makefile, which I created during Winter break. This file had some problem where it won't...

This week I was mainly working on my final design for PenPlotter PCB. I got the routing to work and also added ground plan on both side...

This week I was working on Desiging the pcb. This part was a little bit complicated, then I thought it would be. The parts had to be in a...

This week I mostly worked on designing the pcb which will have ability to control the everything in PenPlotter. This new design will...

This week I worked on building new caster to support heavey pen plotter causing it to lean down and draw rough sketches. The caster is...

This week I worked on mostly the paper roller part of the pen plotter trying to get it to work properly and run it after each print and...

This week I worked on finding a way to stop Arduino from resetting every time it connect, so it doesn't enable the alarm inside the...